Lipolaser — Laser Lipolysis

One of the methods of non-invasive cosmetic procedures, based on the use of modern equipment, is lipolaser, or laser lipolysis. In many cases, this procedure can help restore or maintain a beautiful, graceful appearance of the face and body without the need for surgical liposuction.

The procedure is performed by applying and securing special pads equipped with laser diodes to the problem area. These diodes emit cold-spectrum light with a wavelength of 650 or 940 nm. Therefore, the procedure is also known as “cold laser lipolysis.” This does not imply the use of low temperatures. The patient does not experience any cold or other unpleasant sensations during the lipolysis procedure.

The laser beam selectively targets fat cells in areas where fat accumulates. No other surrounding structures are affected, let alone damaged. Only the permeability of adipocyte membranes and the penetration of enzymes into them are increased. In addition, the laser beam activates biochemical enzymatic reactions, resulting in the breakdown of fat into fatty acids, glycerol, and water.

Thanks to their small size and low molecular weight, as well as the increased permeability of the adipocyte membrane, these substances freely enter the surrounding intercellular space and travel through the lymphatic ducts to the liver. There, they are used as a source of energy and material for building new cells, while the excess is excreted from the body in bile and urine. The fat cells themselves significantly decrease in volume and break down after the fat is released, which is reflected in the body’s contours due to the reduction in its volume. This effect is based on the same processes that occur in the body during natural weight loss.

General recommendations for the cold laser lipolysis procedure:

The duration of a single laser lipolysis (lipolaser) session depends on the body area and takes an average of 30 minutes. The recommended course is 10 laser lipolysis (lipolaser) procedures, two or three times a week. The optimal interval between sessions is 48 to 72 hours!

Clinical studies have shown that the pores created by the laser in fat cells remain open for 24 to 72 hours. To keep the pores open for a longer period and achieve maximum results, the optimal interval between procedures is 48 hours. It is not recommended to skip sessions or exceed 72 hours between sessions. This can significantly reduce the effectiveness of the treatment!

During the course of treatment, you must drink at least two liters of clean water every day — throughout the entire course!